Select the Walls

When you generate panels by using the function on the contextual tab, you can select the walls in the following ways:

• One by one - Select the walls one by one by clicking them. Hold down the Ctrl key.
• All - You can select all walls of a certain type (exterior/interior) at once as follows:
  1. Select one wall in the floor plan or model.
  2. Press Ctrl+A. All walls of the same type will be selected.

• All - If you wish to select both exterior and interior walls at the same time, do as follows:
  1. Select one exterior wall.
  2. Hold down the Ctrl key and select one interior wall.
  3. Press Ctrl+A. All the exterior and interior walls will be selected.

• Area selection - Lock the object type Walls, Exterior and/or Walls, Interior, and select the walls by limiting an area.