Add All Machining Lines to a Panel

Framer

Add all the machining lines defined in the settings to the selected panels as follows:

  1. Select one or more elements. You can select all panels of the same type by pressing Ctrl+A.
  2. Select Panel | Framing | NC Accessories.

    If you have several setup files that define the machining lines, select the machining line to be used from the list.

    You will be prompted: "Update machining lines?"

  3. Select either of the following:
    • Yes - The program adds the machining lines defined in the settings and deletes the single machining lines added earlier.
    • No - The machining lines of the panels will remain unchanged.
Note:
  • Customer-specific machinings are defined in a setup file in the ../custom/setup folder. There can be several setup files. The default file is called CncAccessories.Setup. Other files should be named as follows:

    CncAccessories(DESCR).Setup.

    DESCR is a name describing the machining line. For example:

    CncAccessories(Randek33).Setup

    CncAccessories(Randek55).Setup

    When adding a machining line, the program asks you to select the file to be used. The option Default is the CncAccessories.Setup file.

  • When you are panelizing walls using the method based on the panel drawings, select Classic Wall Framing | NC Accessories, and select the panels.