Rounded Polyline (2D)

General

  • Draw an (open) rounded polyline by clicking points. When you select the Confirm function, the program marks a corner and asks for the rounding radius of all corners in turn.
  • The program also tells you the possible maximum rounding radius and suggests the previous rounding radius.
  • The program does not accept a rounding radius that is too large, but accepts a rounding radius of zero, i.e. in this case the corner remains sharp.

Draw a rounded polyline chain

  1. Select Drawing | Lines | Smart > Rounded Polyline.
  2. Select the line properties, if necessary.

    Line Properties

  3. Draw a polyline by clicking points.
  4. Select Confirm.
  5. Enter a rounding radius to each corner.

Example

  • 1...4: The points of the polyline are clicked
  • 5: Clicking the points of the polyline is finished with the function Confirm.
  • 6...7: The rounding radius of both corners is entered.

Note:
  • Instead of clicking a point, you can enter the point coordinates in a dialog box.