Eave type 1

Framer

L = Top board length

W = Soffit width

D = Distance from click

  1. Select Modeling | Panel | Floor > Framing Accessories. The browser is opened.
  2. Select the Roof Accessories / Eaves folder in the browser.
  3. Select Eave type 1.
  4. Select the parameters in the dialog box:
    • Distance from click (D) - The distance from the selected wall line.
    • Top board length (L)
    • Top board code - Select a cross section for the top board (a) from the profile library by clicking the Select button.

      Part Properties

    • Top board library
    • Soffit width (W)
    • Soffit support code - Select a cross section for the soffit support (b) from the profile library by clicking the Select button.
    • Soffit support library
  5. Confirm by clicking OK.
  6. Select the start and end points of the wall line.
  7. Select the ends of the rafters. Select the ends one by one or use area selection.
  8. Select Confirm.
Note: