Handle Direction or Free Direction as Sweep Direction

Piping Design

If you continue a pipe line from the grip point of a component, the default sweep direction is the same as the grip point's direction.

Do either of the following:

  • Click

    When you select a grip point, the sweep direction is inherited from the grip point.

  • Click

    When you select a grip point, the sweep direction is free. You can add the route of the pipe's or duct's center line in the direction of the main axes X, Y or Z.

Note:
  • If is selected and you click a grip point, you can then release the direction by pressing the F key or clicking the button.
  • You can undo the line to the previous point by pressing Ctrl+Z and then click a different point. You can undo the added points of the same line all the way back to the starting point.