Trim to the Edge of an Area
Architectural, Framer
This function can be used to trim a profile to the edge of an area, for example a floor or a ceiling.
- Select Modeling | Connection | Joint > Profiles Trim to Edge of Area.
- Select the edge.
- Select the joint parameters by using the Parameters function.
- Select the profiles.
- Select Confirm.
If there is already a joint at the end of the profile, you will be prompted: "Remove present joints?" Select either of the following:
- Yes - Remove the old joint and create a new one.
- No - Keep the old joint. A new joint will not be created.