Select the Walls

Framer

When you generate panels by using the function on the contextual tab, you can select the walls in the following ways:

  • One by one - Select the walls one by one by clicking them. Hold down the Ctrl key.
  • All - You can select all walls of a certain type (exterior/interior) at once as follows:
    1. Select one wall in the floor plan or model.
    2. Press Ctrl+A. All walls of the same type will be selected.

  • All - If you wish to select both exterior and interior walls at the same time, do as follows:
    1. Select one exterior wall.
    2. Hold down the Ctrl key and select one interior wall.
    3. Press Ctrl+A. All the exterior and interior walls will be selected.

  • Area selection - Lock the object type Walls, Exterior and/or Walls, Interior, and select the walls by limiting an area.

Note

  • When you are adding panel breaks, the selection method of walls affects the numbering of panels. See Wall Panel Numbering.