Add Cable Joint to a Drawing

Add a cable joint to a table drawing's cable route. If the joint is already located in the table drawing, the function illustrates the current cable route and marks the location with a cross.

The user points the cable route closer to that end, where the distance is given from. If you want to only edit the distance, point first the former cable route and then set the new distance. After this, the software illustrates the new location in the drawing. There is a delay in the software and you can cancel the function by pressing Esc.

1. Select tab Wiring Harness group Locate Joint Connections.
2. Select To the drawing in the database window.