Fix Constraints Automatically

If the assembly is overconstrained, you can try to fix it automatically by pressing F5. The software asks whether you want to fix automatically and executes the function after confirmation. You can cancel the function by pressing Cancel / Ctrl + Z.

The automatic fix sets the constraints in Disable mode one at a time and then tries to solve the assembly's geometric constraints again. Disabling the constraints starts from the newest conflicting constraint, that is not valid. One fixing contains passivating maximum of 50 constraints. If one time was not enough, you can try to fix assembly again.

Fixing the constraints automatically includes in the function Solve External References.

Note:

The software ignores those conflicting constraints, that does not have an identified element.
Set a Tolerance to Constraint Resolution if needed.