Edit Framing Properties

Framer, Floor Framing & Rafters

The properties of a framing have been defined in the structure library by using a framing tool. The framing tool determines the design rules based on which the parts are added to the layer. You can edit the framing tool of the base layer of a structure as follows:

  1. Select the structure.
  2. Do either of the following:
    • Select Plane Structure | Framing | Framing Tools.
    • Right-click to open the context-sensitive menu, and select Framing Tools.
  3. Edit the framing tool.

    Frame - Floor or Ceiling

If the structure has several FRAMING type layers, you can select a layer and then open the framing tool for editing:

  1. Select a structure and a layer of type FRAMING.

    Select a Structure and a Layer

  2. Do either of the following:
    • Select Plane Structure | Framing | Framing Tools.
    • Right-click to open the context-sensitive menu, and select Framing Tools.
  3. Edit the framing tool.

    Frame - Floor or Ceiling

If the part selected in the framing tool is higher or lower than the thickness of the horizontal structure, you can select in a message box whether the top or bottom surface of the structure is to be kept at the original height.

  • Keep Top
  • Keep Bottom

Note

  • You can add framing according to the framing tool by using the Generate Parts function.
  • You can also edit the framing piece properties as follows:
    1. Select the parts to be edited.
    2. Right-click to open the context-sensitive menu.
    3. Select Properties. The Piece Properties dialog box opens. For example, you can select Box + Centerline from the 2D Instance list, whereat you can use the joist center lines to dimension the framing.

      Piece Properties