Add a Truss by Two Points

You can use this function to add a single truss to the truss area with two points. When adding a truss area, the upper and lower limiting structures will determine the shape of the truss.

1. Select Modeling | Panel | Truss Standard Trusses Single Truss by Two Points.
2. Select the truss area by clicking one of the trusses in the area.
3. Select the truss parameters, if necessary. Click the Params button above the status bar. If you cannot see the button, stretch the bottom edge of the Vertex window downwards.

   Truss Parameters

4. Select the start point of the truss.
5. Select the end point of the truss.