Connect Pipe or Duct Lines

When you remove a component between two pipes/ducts, the line is broken. Complement the missing section by adding a pipe or duct line between grip points.

1. Do either of the following:
   • Select Modeling | Pipe.
   • Select Modeling | Pipe Duct.
2. Move the cursor near the grip point of the pipe/duct. The cursor snaps to the grip point. Select the grip point.

   

   The pipe/duct information is determined by the selected grip point.

3. Select the grip point of a pipe/duct to be connected.

   

   The parts are connected. A continuous line is created.

   

Note

• You can also connect parts by adding a grip point linkage between them. A seam is created between pipe or duct parts.