Define Line Direction as Sweep Direction

Profile Structure Design

You can define a line as the sweep direction. You need to define the sweep direction when a point has been selected as the position of the cross section.

  1. Start adding a profile.
  2. Click the starting point of the profile.
  3. Select the line as the sweep direction clicking the following button: Direction of profile sweep (with line)
  4. Select a line from the model.
  5. Click the end point of the profile.
Note:
  • Instead of clicking the button, press the E key when the cursor is over the line.
  • You can undo the sweep direction of the profile defined above, for example
    • By clicking again the button and selecting another line
    • By selecting another auxiliary function.
    • By pressing the U key or selecting the context-sensitive function: Constraint > X axis.
    • By pressing the I key or selecting the context-sensitive function: Constraint > Y axis.
    • By pressing the O key or selecting the context-sensitive function: Constraint > Z axis.