Add a Concentricity Constraint

General

  • A concentricity constraint can be added to circles, arcs and points.
  • In sketch geometry, the symbol for the concentricity constraint is two nested circles .
    • You can use the F9 key to show and hide the symbols of the constraints.

Add a concentricity constraint in a plane sketch

  1. Select the function Sketch | Constraints | Add concentricity constraint.
  2. Click the first circle, arc or point.
    • This circle or arc shall will remain in place unless the element shown below is bound in place with constraints.
  3. Click the second circle, arc or point.
    • This circle, arc or point will move so that it is concentric with the first circle, arc or point.
    • If the last-clicked element is locked in place with constraints, the first-clicked element will move so that it is concentric with the second circle, arc or point.
  4. Repeat steps 2 and 3 to add new concentricity constraints
  5. Stop adding concentricity constraints
    • Select another function or
    • press the V key or
    • press the Esc key or
    • click the middle mouse button.