Construction Line

General

  • The construction line will only be displayed in the sketching mode of part modeling.
  • You can also draw a construction line with a standard two-point line when you select Constr line in the Style group.
  • In the context-sensitive menu, you can find the function Construction line that draws a line with the construction line style.

Sketch a construction line using the context-sensitive function

  1. Select the context-sensitive function Line > Construction line.
  2. Click the start point of the construction line.
  3. Click the end point of the construction line.
    • Before clicking a point, you can use the direction lock provided by the cursor to the X, Y or 45° angle directions.
    • You can also use shortcut keys to lock directions:
      • U: Locks the direction to the horizontal of the sketch plane (X axis direction).
      • I: Locks the direction to the vertical of the sketch plane (Y axis direction).
      • E: Locks the direction in the direction of the line under the cursor.
      • T: Locks the direction in a direction perpendicular to the line under the cursor.
    • Instead of clicking the points, you can enter the relative or absolute coordinates of the points from the keyboard, at the same time the program adds a distance constraint to the line.

      Note that you can first lock the direction of the line and then enter the distance.

  4. Repeat steps 2 to 3 to continue sketching construction lines.
  5. Stop sketching construction lines
    • Select another function or
    • Press the middle mouse button or
    • Press the Esc key or
    • Press the V key (V = Confirm).